Description

We know that many times, our setup of synthesizers and studio equipment changes permanently and with it also the position on the work table.
Taking this into account, we developed a 3-level support, which can be set up in different ways depending on the number of machines that we are going to place and their size.

In the triple stand configuration (using all 4 parts), 3 20cm machines can be placed. deep and a maximum height of 7cm.
This space is enough for much of the hardware available today.

The triple bracket parts are assembled with screws (included) using a universal socket that holds them together firmly.
In turn each part can be used as a simple support. It is only enough to separate the parts by removing the screws and use each part as it suits us.

Each part has rubber feet underneath, so that the support does not slip and is firmly supported.
Both halves of the triple support are linked with wooden rods at various points to give it lateral stability.

The design contemplates space for the rear connectors of each equipment, so that none of them are obstructed by the support.

Measures:
Depth: 58cm
Height: 41cm
Width: 34cm