CUSTOM KIT KORG NTS-1
35,00€
From 3D files released by the brand, we designed a kit for the Korg NTS-1 synthesizer.
It consists of 3 pieces:
Sides – Screw one on each side of the chassis, using the original screws. Tilt the synthesizer to make it easier to access functions. Each side has two rubber feet to prevent it from slipping.
Faceplate – this cover protects the components of the NTS-1 that are visible on the main board.
The display and knobs are protected on the sides, while the rest of the cover with a retro look, reveals inscriptions and functions of the synthesizer.
It is also screwed in using original holes and screws.
Cover – To protect your NTS-1 from dust, pets and in transit.
NOTE: Knobs included in the package doesn’t work with the cover installed.
Additional information
| PACK | Side + Faceplate, Â Side + Faceplate + Cover, Side + Faceplate + Cover + 3 Knobs |
|---|
David –
Generally good experience. Ordering and delivery worked well. The item had no instructions but it’s quite obvious how to put together. There were a few rough edges and surfaces and specifically around where one of the control knobs fit through. I had to sand down (with very fine grain sand paper) these places where the 3D printer process (?) had left some extra plastic but nothing significant.
admin –
Thanks for your feedback, we will take in mind to improve our job. Thanks a lot!
Christopher –
Very cool little stand!
admin –
Thanks Christopher!